- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Cypress,
I want to use EVM kit (CY7C65211-24LTXI) for UART communication,
How shall I set no flow control (use utility?) and "isMsbFirst"?
Below is partial of my setting,
CY_UART_CONFIG cyUARTConfig;
cyUARTConfig.baudRate = CY_UART_BAUD_115200;
cyUARTConfig.parityMode = CY_DATA_PARITY_DISABLE;
cyUARTConfig.stopBits = CY_UART_ONE_STOP_BIT;
cyUARTConfig.dataWidth = 8;
Thank you!
Derlin Chow
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Derlin,
Please use the CyUartSetHwFlowControl() function to set the appropriate flow control. For no flow control, the parameter should be CY_UART_FLOW_CONTROL_DISABLE.
Please refer to the UART API section in the USB-Serial API guide for all the APIs related to UART in vendor mode.
The data is always transmitted LSb (Least Significant bit) first. This cannot be changed.
Thanks,
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Derlin,
Please use the CyUartSetHwFlowControl() function to set the appropriate flow control. For no flow control, the parameter should be CY_UART_FLOW_CONTROL_DISABLE.
Please refer to the UART API section in the USB-Serial API guide for all the APIs related to UART in vendor mode.
The data is always transmitted LSb (Least Significant bit) first. This cannot be changed.
Thanks,
Yatheesh