Hello,
KBA225808 can be tried up to V6.0 of CSD.
CSD V7.0 requires a program modification.
The following of main.c has been changed.
Please see the following thread.
Measure Cmod and Cp of PSoC 4S CapSense for CSD V7.0
Up to CSD V6.0 [The unit of u8_cpValue[] are pF(picofarad).]
From CSD V7.0 [The unit of u8_cpValue[] are fF(femtofarad).]
Be sure to set the following definition in main.c to 0.
(Set to 1 to enable CapSense Tuner.)
Build this project and program it into CY8C4045AZI-S413 of CY8CKIT-145-40XX.
Here, if a program for I2C communication with CY8C4045AZI-S413 is written in CYBLE-022001-00, it will not work properly.
Use the PSoC Programmer to erase the CYBLE-022001-00 program.
Launch the Bridge Control Panel and follow the steps below to open V70_2ch Cp.iic and V70_2ch Cp.ini.
1. [File] -> [Open File...] -> [V70_4ch Cp.iic] open
2. [Chart] -> [Variable Settings] -> [Loading...] in Submenu -> [V70_4ch Cp.ini] open -> [OK] in Submenu
3. Click the following line in the [Editor] tab.
r 08 x x x x x @0WID0 @1WID0 @2WID0 @3WID0 @0WID1 @1WID1 @2WID1 @3WID1 p
4. Select the [Chart] tab next to the [Editor] tab and click [Repeat].
Then, touch SLD0(0.0) and SLD4(0.6).
Click the next line in the [Editor] tab if you want to see the Cmod value.
r 08 x @0CMOD @1CMOD @2CMOD @3CMOD x x x x x x x x p
And change the valiable settings of [Chart].
Best regards,
Yocchi
