- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
just want to know where actually the INT of sensors (for example LPS25H - INT1 pin 7 is stated that connected to TP12) in .pdf file
where actually those (TP8,9,10,11,12,15,16) are connected to BCM20737S or aren't we using them those INT ?
thanks in advance...
Regards
Sid
https://community.broadcom.com/servlet/JiveServlet/previewBody/1642-102-4-1655/WICED_SENSE_Schematic... |
Solved! Go to Solution.
- Labels:
-
WICED Sense
- Tags:
- sensor interrupt
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi rsiddhanth,
The interrupts from the sensors aren't connected to the chip, they're only brought out as test points.
There are some free GPIO brought out as test points on that board which can be fly wired to any interrupt's test point.
Jacob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi rsiddhanth,
The interrupts from the sensors aren't connected to the chip, they're only brought out as test points.
There are some free GPIO brought out as test points on that board which can be fly wired to any interrupt's test point.
Jacob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you very much for clarifying my doubt, jakewtorres...
Regards
Sid