- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using CY8C5888 eval board.I am trying to setup an generic USB (64byte data exchange). I read the datasheet of USB and had a look onthe mouse implemenation. I also had a look on the USB UART implementation. In mouse implemenation there is only one endpoint. In USB UART there are three endpoints. I expect 3 endpoints for HID generic also. One control, one IN and one OUT endpoint. How shall I configure and how is the process to set the endpoints.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I found an application note using two endpoints for one HID.
https://www.cypress.com/an82072
AN82072 - PSoC 3 and PSoC 5LP USB General Data Transfer with Standard HID Drivers
In the section "6 Example Project: Generic Data Transfer via HID" an HID device project is created using Generic HID.
Please check if this document can be used.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We don't have a code example using HID Generic for PSoC 5LP, but we have for PSoC 6. You can refer to the USB Descriptor and replicate it in your PSoC 5LP project.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I found an application note using two endpoints for one HID.
https://www.cypress.com/an82072
AN82072 - PSoC 3 and PSoC 5LP USB General Data Transfer with Standard HID Drivers
In the section "6 Example Project: Generic Data Transfer via HID" an HID device project is created using Generic HID.
Please check if this document can be used.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Noriaki,
thanks !! This was the information that made my application working.
Best regards
Rupert