- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i wnat ability of printf message to pc terminal via power sdk via usb pd ? it is possible ?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. You could implements a USB to UART with CCG3 to print message to PC terminal via power SDK, since CCG3 have a FS USB block inside. The part number can be refer to SPEC 002-03288
:
2. Or, the other way, Add a USB to UART (RXD) on Dp and Dm of CCGx device (except CCG3 above) and add a UART TXD component into firmware project.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. You could implements a USB to UART with CCG3 to print message to PC terminal via power SDK, since CCG3 have a FS USB block inside. The part number can be refer to SPEC 002-03288
:
2. Or, the other way, Add a USB to UART (RXD) on Dp and Dm of CCGx device (except CCG3 above) and add a UART TXD component into firmware project.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i have cypd3175
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CYPD3175 is CCG3PA, CCG3PA do not have FS USB block inside, it cannot implemnts CDC.
Best Regards,
Lisa