- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have following error during build the project in EZ-USB Suite
11:22:21 **** Incremental Build of configuration Default for project Firmware ****
make all
Cannot run program "make": CreateProcess error=2, The system cannot find the file specified
Error: Program "make" not found in PATH
PATH=
11:22:21 Build Finished (took 50ms
Thanks
Esakki
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Esakki,
The project settings are completely different from any of our example projects.
So, can you please take the project folder from https://www.cypress.com/documentation/application-notes/an75779-how-implement-image-sensor-interface... and replace your source files in that? And then perform clean and build.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Esakki,
Can you please attach your project folder here?
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Hemanth,
How to insert project folder or zip file in forum?
Thanks
Esakki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Hemanth,
For reference I attached project file screenshot.
Thanks,
Esakki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Esakki,
You can click on Use Advanced Editor on the top right corner of the reply window, which would open a new page.
Click on Attach (bottom right corner) and you can attach .zip files here.
Regards,
Yashwant
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Yashwant!!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Esakki,
The project settings are completely different from any of our example projects.
So, can you please take the project folder from https://www.cypress.com/documentation/application-notes/an75779-how-implement-image-sensor-interface... and replace your source files in that? And then perform clean and build.
Regards,
Hemanth