- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
is it possible to use the CY8CKIT-142 board as stand alone, only powered by 5 V to receive commands from a self developed App and generate a PWM signal on an output to drive a transitor with a frequency of 200 Hz and depending on the transmitted AT command a duty cycle between 10 and 90 % ?
If so, would it be right to start with the development kit, build the software for the module and for the Android app?
Thanks, all the best,
Frank
Solved! Go to Solution.
- Labels:
-
ispn:40038:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi frki_4757601,
Yes, you can use CY8CKIT-142 for your application. You can use these training videos for reference - https://www.cypress.com/training/psoc-video-tutorial-series-how-create-android-apps-interact-cypress...
Hope this helps,
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi frki_4757601,
Yes, you can use CY8CKIT-142 for your application. You can use these training videos for reference - https://www.cypress.com/training/psoc-video-tutorial-series-how-create-android-apps-interact-cypress...
Hope this helps,
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks a lot, als parts still ordered.