- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just purchased the 062 kit, and following the lesson 1-3 Hello World video, the build was successful yet the LED5 does not blink. I have followed the video step by step to make sure there were no errors on my end. I found a question that had the same issue but was answered with steps on how to select debug target. I went to select the debug target but the list is blank, even after restarting the program.
I had a warning the first build that said a value was truncated because it was too large, but I ran it again after following the video once more and build was successful w/no warnings. LED5 still didn't show.
Not really sure where to go from here.
Really need to get this board working since I am using it for a project, I appreciate any responses in advance. Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1:
Please check if you have configure the right pin in the .cydwr .
2:
Please check which version of the KIT you have. Rev11 or Rev13 ?
3:
More details, you can refer to the CY8CKIT-062 user guide.
https://www.cypress.com/documentation/development-kitsboards/psoc-6-ble-pioneer-kit-cy8ckit-062-ble
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1:
Please check if you have configure the right pin in the .cydwr .
2:
Please check which version of the KIT you have. Rev11 or Rev13 ?
3:
More details, you can refer to the CY8CKIT-062 user guide.
https://www.cypress.com/documentation/development-kitsboards/psoc-6-ble-pioneer-kit-cy8ckit-062-ble