- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everybody,
i want to use PUART for communication between BCM920704 and ST chip.
but i can not handle that.
basic infomation..
- SDK : WICED-SmartReady-SDK Version: WicedBTHomeKit_001.003.001.0105
- demo application : hal_puart_app
- dev kit : BCM920704PEVAL
it is PUART setting.
--- snip ---------------------
wiced_hal_puart_select_uart_pads( 33, 0/*31*/, 0, 0);
--- snip ---------------------
i attached source file.
could you let me give a clue?
Thanks,
GyoungBo Min
Solved! Go to Solution.
- Labels:
-
Peripherhal UART
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The BCM20704 is not supported here on the community, so you will want to contact one of our regional Distributors to arrange support for this product.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The BCM20704 is not supported here on the community, so you will want to contact one of our regional Distributors to arrange support for this product.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi roychang
Mr. Min will use 20706 finally, but they are using 20704 temporarily due to board shortage. Customer is asking that WICED-Smart-Ready SDK is supporting PUART sample code.
Best Regards,
Solomon
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content