Aug 14, 2020
01:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 14, 2020
01:07 AM
Hi,
When I try to set the logic of the GPIO pins using 'SIOL' command I am getting bad command error.
eg:
PAD 11 GPIO_0: GPIO_0/P36/P38
I want to set the logic HIGH of GPIO_0, I used this command 'SIOL,P=36,L=1' and response attached. Am I missing something?
Labels
2 Replies
Aug 16, 2020
07:18 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 16, 2020
07:18 PM
There should be a carriage return at then end of the command. Please check if you miss it?
Aug 16, 2020
07:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 16, 2020
07:25 PM
I am already getting responses for other commands without a problem. Please see attached for the EZ-Serial FW version