Booting a Factory-Fresh Murata 1GC-based Board (CYW43907 chip)

[ChMa_3922746]

On a factory fresh board with a Murata 1GC installed on it (CYW43907 chip) and a blank SPI EEPROM, is anything other than the WICED SDK and a JTAG interface needed to put all the software/firmware (incl. Murata WIFI fw) on the board and have it boot?

Put another way, if a factory fresh board is connected only via JTAG to the WICED SDK (via the appropriate dongle, such as on the EVAL board), is that enough to boot it and have it run regular software?

Thanks!

[Zhengbao_Zhang · Accepted solution]

Hello:

    If you want to flash the board, I think JTAG interface is needed. via the appropriate dongle , this is correct.

For Wiced SDK we don't need it always because we can download the flash by script also..

[ChMa_3922746]

Perfect, thank you.