- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How I can configure puart flow control?
I made two changes but it did not work well.
one
const wiced_platform_gpio_t platform_gpio_pins[] =
{
...
[PLATFORM_GPIO_4 ] = {WICED_P06, WICED_UART_2_RTS },
[PLATFORM_GPIO_5 ] = {WICED_P07, WICED_UART_2_CTS },
...
two
wiced_hal_puart_flow_on();
Please let me know how I can make it.
Solved! Go to Solution.
- Tags:
- cybt-413034
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In my test, CYBT-413034 made compile error wiced_hal_puart_select_uart_pads
I changed my target UART control setting and I could use PUART flow control.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Did you select the Tx,Rx, cst,rts pins for the UART hardware using wiced_hal_puart_select_uart_pads() ?
BOOL32 wiced_hal_puart_select_uart_pads(UINT8 rxdPin, UINT8 txdPin, UINT8 ctsPin, UINT8 rtsPin);
How did you implement the flow control in your application? May I know the code flow?
Please attach the PUART code snippet here, if possible.
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In my test, CYBT-413034 made compile error wiced_hal_puart_select_uart_pads
I changed my target UART control setting and I could use PUART flow control.
Thanks!