- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The vhdl/verilog model delivered with s25fl128s are merely basic. I have a large simulation using a preliminary programing sequence followed to reading sequences.
It is actually painful to debug on waveform every SPI access to decode commands, address and so on.
I would need a realistic model being able on the top on the functional use to decode commands, address, data received and dump this into log.file
Do you know if such model exists...
Any help is welcome.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Clement,
S25FL128S advanced verilog model with verbose debug is not available. The models we provide to customers are to check HW connectivity and low-level transactions.
Thank you
Regards,
Bushra
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Clément,
Thank you for contacting Cypress Technical Support, an Infineon Technologies Company. I don't think S25FL128S advanced verilog model with verbose debug is available but I will reconfirm with our modeling group and see if there are any other available.
Regards,
Bushra
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Clement,
S25FL128S advanced verilog model with verbose debug is not available. The models we provide to customers are to check HW connectivity and low-level transactions.
Thank you
Regards,
Bushra
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I understand but those low-levels transactions are not tracked.. you have to debug waveforms... this is sluggish....
I think it could be a good idea to have this feature included in your models.
The work around here is to develop a "spy" model decoding SPI commands sent over the line and dump them in a file.
That's a real pity your model could not do so because I have to develop something over the top
that Cypress as a device provider could provide embedded in its models.
Think that those models are also used by HW engineers not only SW.
Thanks anyway
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Clément,
Thank you for your response. I will pass on your valuable feed back to our modeling group.
Have a wonderful day
Regards,
Bushra
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Clément,
I checked with our modeling group. They said protocol checking/logging for s25fl128s can be done, if you are willing to pay for it.
Thank you
Regards,
Bushra