- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I check cypd3125 SDK , only support 5V, 9V, 15V, 20V. But I want to chenge output voltage 12V.
How can I do?
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please save the configuration with the 12V PDO first, it will generate a *.cyacd, *.xml and *.c file, and replace the config.c file in the project with the modified one. Once you do that, kindly rebuild the project and program the firmware file.
If you still see 20V, it could be possible that the PD contract happens at 20V even with 12V added as the sink may be requesting for the same.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
You could add a source PDO that supports 12V using the EZ-PD Configuration Utility and program the device with the new configuration.
Please refer to the Configuration Utility Guide for more details-https://www.cypress.com/file/183686/download
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I already tried this way, I builded CYPD3125-40LQXI_notebook, andf I changed PDO (deleted 15 and 20V, changed 9V to 12V), saved to CYPD3125-40LQXI_notebook_1.cyacd, then I updated firmware, but it did not work , ouput voltage was still 20V.
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please save the configuration with the 12V PDO first, it will generate a *.cyacd, *.xml and *.c file, and replace the config.c file in the project with the modified one. Once you do that, kindly rebuild the project and program the firmware file.
If you still see 20V, it could be possible that the PD contract happens at 20V even with 12V added as the sink may be requesting for the same.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I added 12V PDO , replaced config.c, rebuilt the project. It worked as my design. Thanks very much.