- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am wondering how would I be able to send a UVC i2c command to the fx3 using the streamer application from the FX3 sdk in windows/Linux?
Thank you,
Ryan
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Ryan,
Fx3 Streamer Application is designed to check the maximum throughput that can be achieved through an Endpoint of Fx3 or FX2LP device configured in Vendor mode and bound to Cypress cyusb3 driver.
So, you cannot use Streamer application to send any commands to the Fx3 device.
Alternatively, if you have a vendor interface in your FX3 UVC firmware, and if the interface is bound to cyusb3 driver then you can use Control Center to send vendor commands to the FX3 Device.
Thanks,
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Ryan,
Fx3 Streamer Application is designed to check the maximum throughput that can be achieved through an Endpoint of Fx3 or FX2LP device configured in Vendor mode and bound to Cypress cyusb3 driver.
So, you cannot use Streamer application to send any commands to the Fx3 device.
Alternatively, if you have a vendor interface in your FX3 UVC firmware, and if the interface is bound to cyusb3 driver then you can use Control Center to send vendor commands to the FX3 Device.
Thanks,
Yatheesh