- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good afternoon
I am using the CYBT-213043-MESH kit
I need help with this code, we need help with BLE MESH
I can scan devices and I can send them by message through the mesh network
The problem in this code in the function:
void mesh_vendor_server_send_adv_data (uint8_t * bda, int8_t rssi), datps send very slow
The data is sent every 200 milliseconds, I want the data to be sent faster,
Can you help me to send this data as quickly as possible?
Please
can you please help me?
this is very urgent
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Did you try to change the current_time_ms - last_timestamp_sent_ms < 200 to a lower value?
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Did you try to change the current_time_ms - last_timestamp_sent_ms < 200 to a lower value?
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yes, I already changed it to 25 miliseconds, but the board did not change the data sending speed,
Although I put 25miliseconds or 50miliseconds it does not increase the speed, the maximum it increases is approximately 200 miliseconds
could you please help me increase the speed?
this is urgent for our company, we believed that it would already work well, but when we did tests, we found that it is very necessary to increase the speed to the maximum
we need the data to be sent faster
can you try to increase the transmission speed?
please
could you help us?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The application will be scanning for the devices with the configured values (scan_interval, scan_window) in the wiced_bt_cfg.c of mesh-app_lib. Varying these values can make an impact on current consumption, performance, etc.
For, mesh both these parameters are configured as same (96), because to be a good mesh citizen a node should be listening for the packets as close to 100% of the time as possible.
Could you please explain why do you need to scan for ble devices faster? What is the application scenario?
Thanks,
-Dheeraj