- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
SAR_ADCにあるoverrun_det フラグを使用して異常を検出したいのですが、
このフラグはデフォルトでDisableのようです。
Enableにできる(このフラグは使える)のでしょうか。
もしできるのであれば設定方法を教えてください。
-----------------------------------------------------
Is it possible to enable the overrun_det flag function in ADC_SAR_WRK1_REG?
If yes, please tell me how to enable.
Solved! Go to Solution.
- Labels:
-
PSoC 5 Architecture
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
There is one more register to enable this feature. In the register TRM of the device kindly check (SAR[0..1]_CSR5) register. The bit overrun_det_en enables data overrun detection. Once you enable this feature, you can check data over-run. I have tested the feature at my end, using test project attached.
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
There is one more register to enable this feature. In the register TRM of the device kindly check (SAR[0..1]_CSR5) register. The bit overrun_det_en enables data overrun detection. Once you enable this feature, you can check data over-run. I have tested the feature at my end, using test project attached.
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Vasanth-san,
Thank you for your support.
I will check it.
Thanks,
Tetsuo