- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
When I used EZ-PD Configuration Utlity to update firmware that I configurated, window showed as screenshot below. I couldn't complete firmware upgrade.
How can I solve the problem? Does it mean I configurate wrong on the EZ-PD Configuration Utlity? What I configurated is sth about Source PDO in CCG3 NOTEBOOK.
Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you remove the Chinese character in the path? Make sure EZ-PD Config Utility have access to the generated config file. Or you can try it in another PC if it is possible.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
EZ-PD Config Utility could not recoginze the firmware file if its path is too long. Could you reduce the length of path and try again?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I ready tried to reduce the length of path and put the path on the desktop of PC. But it doesn't work again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you remove the Chinese character in the path? Make sure EZ-PD Config Utility have access to the generated config file. Or you can try it in another PC if it is possible.