- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We bought a cybt-343026 programmer and it failed to install the driver, could you please give us some advice? we are using win7 64 bit and windows xp 32bit system
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There is no particular driver needed for programming the module. Make sure your HCI COM port is not open anywhere else. Can you check the configuration mentioned here- Programming CYBT-413034-02-EVAL
I have tested with CYBT-343026 module, it works fine.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yy_4726631,
Are you talking about WICED Module Programmer User Guide – KBA225060 ?
It should work on your system. Please re-install & follow the steps given in the KBA.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Yes, we are talking about WICED Module Programmer User Guide – KBA225060 ,
when selecting Serial port, it show KitProg Programmer instead of COM port,
we do need a driver for this device.
Thanks,
Yart
"SheetalJ_96"
<community-manage
r@cypress.com> To
YART LIU/PE/DG_CMS/VTECH@VTECH
06/26/2020 12:38 cc
PM
Subject
Re:
Please respond to - cybt-343026 prog usb driver
jive-559208296-1j
qw-2-55lg@broadco
mwiced-v8.hosted.
jivesoftware.com
Cypress Developer Community
cybt-343026 prog usb driver
reply from SheetalJ_96 in WICED Studio Bluetooth Forums - View the full
discussion
Hi yy_4726631,
Are you talking about WICED Module Programmer User Guide – KBA225060 ?
It should work on your system. Please re-install & follow the steps given
in the KBA.
Reply to this message by replying to this email, or go to the message on
Cypress Developer Community
Start a new discussion in WICED Studio Bluetooth Forums by email or at
Cypress Developer Community
Following cybt-343026 prog usb driver in these streams: Inbox
This email was sent by Cypress Developer Community because you are a
registered user.
You may unsubscribe instantly from Cypress Developer Community, or adjust
email frequency in your email preferences
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There is no particular driver needed for programming the module. Make sure your HCI COM port is not open anywhere else. Can you check the configuration mentioned here- Programming CYBT-413034-02-EVAL
I have tested with CYBT-343026 module, it works fine.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Finally I installed PSoC Software - Cypress Semiconductor, then the driver of the programming adaptor 343026-01 automatically installed.
if no driver installed, we can not select corresponding COM port.
Thanks for your help.