- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am building a controller around S6E2GM6J0AGV2000A. I came across documentations that showed that it can be programmed using USB and RS232 protocols. Is debugging possible when programming using these protocols? Can JTAG protocol be used for programming and debugging? If yes, then is there any Cypress programmer available for the same?
P.S. - I am fairly new to controller design
Solved! Go to Solution.
- Tags:
- and fm4 family
- fm4
- fm4 family
- fm4 series
- fm4-176l-s6e2gm
- fm4_mcu
- mcu & psoc: fm4 32-bit arm cortex-m4
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The following documents may help you more or less on the topic FM4 programming and debugging -
https://www.cypress.com/file/258111/download https://www.mouser.com/datasheet/2/100/readme_sk-fm3-48pmc-mb9bf524k-933906.pdf
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The following documents may help you more or less on the topic FM4 programming and debugging -
https://www.cypress.com/file/258111/download https://www.mouser.com/datasheet/2/100/readme_sk-fm3-48pmc-mb9bf524k-933906.pdf
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks ShipingW_81. Those documents were very helpful.