- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am new to modus toolbox and tried learning how to use it with the youtube tutorial series by cypress but the GUI seems to have changed quite a lot. I cannot find where the design resources are (pins, etc) like in psoc creator.. The peripherals tab is empty https://happymod.site/ https://100001.onl/ https://1921681254.mx/
Is there a series of videos for a quick learning curve for the most recent modus toolbox software?
I also have very few code examples for the PSOC6 wifi-BT pioneer ki compared to what was available in the youtube videos. How can I get more examples? I wanted to get an example code for the Oled screen that comes with the kit too.
Thank you!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Modus does not have a schematic representation like Creator, but some components are available. For Modus 2.1, you can set Pin, PWM, Timer, and so on using Device Configuration Tool. The sample code in this Tool was few, so I posted the basic one. I'm glad if you can use them as a reference.
LED and Switch - A simple program for beginners using Modus Toolbox2.1 with PSoC6(M4)
LED and Switch with interrupt - A simple program for beginners using Modus Toolbox2.1 with PSoC6(M4)
UART to output message - A simple program for beginners using Modus Toolbox2.1 with PSoC6(M4)
Regards,
Kenshow
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, the youtube tutorial series on ModusToolbox is quite old and a lot of changes have happened since then.
We heard you and we have created a blog series to help you ramp up on ModusToolbox quickly. More blogs will be added to this series on a regular basis. Here are two of them you can get started with:
(1) Session 1: Introduction to ModusToolbox 2.x
(2) Session 2: Introduction to Digital Peripherals in ModusToolbox
I created the blog posts just now, so you might have to wait for the video to get encoded and become available. But it should be ready for viewing in a couple of hours.
I hope you enjoy the content!
You can find all the code examples for ModusToolbox here: Cypress Semiconductor Corporation · GitHub
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Modus does not have a schematic representation like Creator, but some components are available. For Modus 2.1, you can set Pin, PWM, Timer, and so on using Device Configuration Tool. The sample code in this Tool was few, so I posted the basic one. I'm glad if you can use them as a reference.
LED and Switch - A simple program for beginners using Modus Toolbox2.1 with PSoC6(M4)
LED and Switch with interrupt - A simple program for beginners using Modus Toolbox2.1 with PSoC6(M4)
UART to output message - A simple program for beginners using Modus Toolbox2.1 with PSoC6(M4)
Regards,
Kenshow