- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just received a CYCKIT-042-BLE-A and I’m trying to run AN91184. The device on the
The PSoC 4 BLE Module has a CY8C4248LQI-BL583. The module sits on the EZ-BLE Pioneer Arduino Baseboard (CY8CKIT-143A) which has a PSoC 5LP CY8C5868LTI-LP039.
The project builds without a problem but Debug | Target doesn’t find .
The firmware has been updated.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Jim,
Can you only connect the baseboard CY8CKit-042 via USB to your system and try to acquire the port and program the device and share the result. I used your project and i am able to program my board with your attached project.Thus i am not able to replicate your issue at my end. Also can you once go to the PSoC Creator project tab-> Update Components and update all the used components. Also can you go to Project->Device selector and select CY8C4248LQI-BL583 as your device.
Also can you once reinstall the driver for Kitprog from device manager.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you follow section 3.5 from the below document (link below) and let us know what results are you observing. ( Screen shots will be very helpful)
https://www.cypress.com/file/234851/download
Thanks,Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Jim,
Can you only connect the baseboard CY8CKit-042 via USB to your system and try to acquire the port and program the device and share the result. I used your project and i am able to program my board with your attached project.Thus i am not able to replicate your issue at my end. Also can you once go to the PSoC Creator project tab-> Update Components and update all the used components. Also can you go to Project->Device selector and select CY8C4248LQI-BL583 as your device.
Also can you once reinstall the driver for Kitprog from device manager.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for keeping us posted and returning with the details.
Regards,
Pradipta.