- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
In order to manage different hardware variants of hardware in a single project (controlled by a config file), is it possible to enable / disable schematic pages created in PSoc Creator using #ifdef?
Something like:
#ifdef i2c-comm
i2c_page = enabled;
serial_page = disabled;
usb_page = disabled;
#endif
#ifdef serial
i2c_page = disabled;
serial_page = enabled;
usb_page = disabled;
#endif
... and so on....
Solved! Go to Solution.
- Labels:
-
PSoC Creator Software
- Tags:
- ifdef
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
VaCe,
General answer is No, but there are some options available. Please check previous discussion on the subject,
/odissey1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
VaCe,
General answer is No, but there are some options available. Please check previous discussion on the subject,
/odissey1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
With /odissey1-san's hint, I wrote a following sample.
PSoC Creator Schematic Page Enable/Disable Sample
I hope this can be a hint, too 😉
moto