- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Who do I contact to get the hex/bin file to program this? Is there any way to get source if any tweeks are needed?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
For the HEX file, may I know what's part number of CCG3PA on your board?
Could you please kindly contact local Cypress FAE/sales and request them contact Cypress AE team to get the firmware project?
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apparently no one. These parts have been out for a year and I have asked Qorvo and Cypress questions and for help on getting some code for this design with one response from a Qorvo guy in GB that asked me what location I was in and then crickets. Perfect part for the project but no help. Going to start looking at other solutions for this customer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
For the HEX file, may I know what's part number of CCG3PA on your board?
Could you please kindly contact local Cypress FAE/sales and request them contact Cypress AE team to get the firmware project?
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Lisa,
I am using the cypress part CYPD3175-24LQXQ.
Thanks for responding.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Kindly use the HEX file attached.
Best Regards,
Lisa