- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Setup
PSoC creator 4.3 example project of EZ-PDCCGx PowerSDK recognize the eval kit
Status main board jumpers:
J2,3,4 short 1,2 pins
J6 short 2,3 pins
J5,7 open
Status power board j6,j7,j9 short 1,2 pins
The debug option still disable please advice in PSoC creator 4.3
see atthached images which describe all needed configuration such as : config port config debug ........
thr debug option still disable
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you please select "noboot" project in the PSoC Creator Workspace as current project and try debugging?
Regards,
Pranava
Pranava
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
where i find noboot project
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The "noboot" project will be in the Workspace along with example project you have opened. You can find them in the Workspace Explorer tab after opening your example project.
Regards,
Pranava
Pranava
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content