- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
I have a big problem in my PCB project, I need to use 2 SCB components (SPI and I2C) but I make a mistake in choosing their pins and I can only access SPI or I2C in separate projects. The pins I choose are the following and I found out only now I mixed SCB0 and SCB1 pin for SPI and I2C. I would like to know if it exists a solution to solve the problem without soldering two flying wires on different pins as 3.4 3.5 or 5.0 5.1.
Thank's for all who wants to give an advice.
Francesco
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Francesco,
Since this module does not have UDB components, you have to connect to wires externally.
Regards
Alakananda
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Francesco,
Since this module does not have UDB components, you have to connect to wires externally.
Regards
Alakananda