- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm interested in using CY4521 evalkit. However from looking at the schematics I don't understand how the CCG2 communicates the source voltage setting to the DC/DC on the base board. The VSEL lines are not connected to the CCG2 anywhere?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the kit schematics, TP17, TP20 and TP18, TP21 are test points through which you can can be mount two-pin jumper headers or solder resistors. These could be loaded when you are not SWD programming the CCG2.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the kit schematics, TP17, TP20 and TP18, TP21 are test points through which you can can be mount two-pin jumper headers or solder resistors. These could be loaded when you are not SWD programming the CCG2.
Best Regards,
Sananya