- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
PSoC Creator 4.3 (4.3.0.1445) continues to close unexpectedly. I am also running Atmel Studio 7.0.2397. win 10 Version 1903 x64.
This is a very annoying problem as the project has the two processors communicating with each other and i need to have both IDE's open at same time.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The PSoC Creator might not have installed correctly. Have you tried uninstalling and re-installing it again? Please go through following Troubleshooting guide. All the possible issues are addressed here.
Troubleshooting PSoC® Creator™ Issues - KBA217546
Mainly, please check section 2 of the trouble shooting guide.
Is the issue happening when you open only PSoC Creator application and nothing else?
Please try above mentioned points and update.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The PSoC Creator might not have installed correctly. Have you tried uninstalling and re-installing it again? Please go through following Troubleshooting guide. All the possible issues are addressed here.
Troubleshooting PSoC® Creator™ Issues - KBA217546
Mainly, please check section 2 of the trouble shooting guide.
Is the issue happening when you open only PSoC Creator application and nothing else?
Please try above mentioned points and update.
Thanks
Ganesh