- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have a
CY8CKIT-042 PSoC 4 Pioneer Kit
When i connect to it using the psoc programmer it look like it connect to my attached module.
I can't update the fw in it because the Utilities -> Upgrade Firmware is greyed out ?
How can i upgrade the fw in the kit ?
Br
Esben
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi EsFr_4600111,
CY8CKIT-042 PSoC 4 Pioneer Kit has KitProg loaded. I think your KitProg is in Mass Storage Programmer mode as shown -
Can you try pressing and holding the reset switch (SW1) of the kit for more than 5 seconds? The Status LED of the kit turns off when the KitProg changes configurations.
Let me know if this works.
For more information regarding the Mass Storage Programmer mode, please refer to section 4.1 in KitProg User Guide
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi EsFr_4600111,
CY8CKIT-042 PSoC 4 Pioneer Kit has KitProg loaded. I think your KitProg is in Mass Storage Programmer mode as shown -
Can you try pressing and holding the reset switch (SW1) of the kit for more than 5 seconds? The Status LED of the kit turns off when the KitProg changes configurations.
Let me know if this works.
For more information regarding the Mass Storage Programmer mode, please refer to section 4.1 in KitProg User Guide
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much it was the problem !!