Cannot program with my PSoC 6 Pioneer

[StMa_3607891]

I cannot program the target with my PSoC 6 Pioneer board.

Often the target is not recognised by the programmer and when it does it starts programming and fails half way.

LEDs 2 & 4 very erratic.

The KitProg 3 is always shown in Windows Device Manager.

I followed a suggestion I saw online to uninstall the driver and then re-install but that did not help.

I opened up PSoC programmer and noticed that the Voltage reading on the programmer tab was visibly flatulating all over the place.

PSoC programmer once told me that I needed to upgrade which I did successfully, but the problem still existed.

Any ideas anybody please?

[Rakshith · Accepted solution]

Hi StMa_3607891​,

A couple of debug steps -

1. VDD Select Switch SW5 should be in the middle position (3.3V)
2. Switch SW7 (back of the Kit) should be VDDD/KitProg2
3. Power monitor jumper J8 needs to be connected.
4. KitProg3 should be in BULK mode. You get find information regarding the KitProg3 LED status here - KitProg3 User Guide​

If this does not help, please share the screenshot of PSoC Programmer when you try to program the device.

Thanks and Regards,

Rakshith M B

[StMa_3607891]

Hi Rakshith,

Thanks man, it seems to work now. It must have been SW7 which all by itself decided to slide all the way to the other side!

Regards,

Stephen.

[Rakshith]

Hi StMa_3607891,

Glad your issue is resolved

Regards,

Rakshith M B