- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everybody,
I'm working on a ccandc. I would know if there is a possibility to choose one of the b/g/n mode while programming.
By the way, I'm using the WICED-SDK-3.3.1 version.
And I use a BCM43438 on SoftAP mode.
Thank you all.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes. There are APIs for controlling 11n mode ON or OFF and also data rates for 11b/g
These APIs can work in AP mode as well as STA mode
But in general given there is only one radio - if you set a mode for AP it will impact STA as well
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, Naren. Thank you for your quick reply.
I find the APIs from WICED 3.3.1 version. I don't know whether it is correct.
API:
wwd_result_t wwd_wifi_set_legacy_rate( wwd_interface_t interface, int32_t rate)
wwd_result_t wwd_wifi_set_11n_support( wwd_interface_t interface, wiced_11n_support_t value)
--
ccandc
Webb
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
These are the correct APIs
Suggest that you move to newer SDK
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi nsankar
wwd_wifi_set_11n_support API only STA supported. But my BCM43438 is on SoftAP mode.
The API return a WICED_ERROR on SoftAP mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you make sure that the WIFI interface is down by calling wiced_wifi_down before using this API?
Also can you use SDK 3.5.2 to verify this?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, Naren. Thank you.
I will try the API on the SDK 3.5.2.