CYW20734 Help:How to get into DUT mode?

[gahe_4691766]

Start the BlueTool(ver0.1.55.1) application,save the UART option,then set the following options:

a、Select7.3:Host Controller & Baseband Commands  from the command list, then double-click the

Reset command.After double-clicking the Reset command, the log window should indicate Success for the reset

status.

b、Select7.3:Host Controller & Baseband Commands  from the command list, then double-click the

Write_Scan_Enable(Inquiry and Page Scan enabled) command,the log window should indicate Success.

c、Select7.6:Testing Commands,then double-click the Enable_Device_Under_Test_Mode command,

the log window should indicate Success.

Try to connect 20734,the log window event = 0x04(Connection Request), Link_Type = 0x01("ACL connection") ,a few seconds later,the log window event = 0x03(Connection Complete),Status = 0x10(Connection Accept Timeout Exceeded)..

What else step can I do to solve this problem？By the way,is there an instruction manual for testing CE?

[AnjanaM_61 · Accepted solution]

Hi gahe_4691766 ,

As the 20734 is not designated as a broad market device that is supported here on the community, please work with the local Cypress sales/distribution team for the queries.

Regards,

Anjana

[gahe_4691766]

Thanks!