- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello. I am trying to flash bootloader (DFU) to PSoC 6 so I can update the firmware via UART. I have read lots of notes and got a bit confused. Can you please help me or guide me on how to do that with simple steps? any help appreciated.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Have you gone through code examples present in PSoC Creator? If no, please go through the code examples "PSoC6DFUbasicApp0Uart" and "PSoC6DFUBasicApp1" in PSoC Creator code examples section. You will also get a document with these code examples which has step by step procedure to bootload your application through UART/SPI/I2C.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Have you gone through code examples present in PSoC Creator? If no, please go through the code examples "PSoC6DFUbasicApp0Uart" and "PSoC6DFUBasicApp1" in PSoC Creator code examples section. You will also get a document with these code examples which has step by step procedure to bootload your application through UART/SPI/I2C.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the reply. No I did not try. I think that's what I need I will try to implement this example and see what I got.
Thanks
Sabah