- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
We are looking for a stand alone USB3.0/3.1 Hub in our embedded application to increase the number of USB 3.1 port. Stand alone USB hub in the sense, we dont want to use the EEPROM or I2C master(or minimum setting) to configure the USB HUB and USB hub should work with default pre-programmed configuration with out much dependency on the controller.
Can you please suggest us the IC to serve our purpose.
Thanks in advance,
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please check HX3 which provides four USB 3.1 downstream ports. You can set the hub boot mode to internal ROM which has default programmed firmware and configuration for the hub. Please refer to page 24 in the datasheet for more details.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please check HX3 which provides four USB 3.1 downstream ports. You can set the hub boot mode to internal ROM which has default programmed firmware and configuration for the hub. Please refer to page 24 in the datasheet for more details.
Best Regards,
Sananya