Stand alone USB3.0/3.1 Hub

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
rah_4677131
Level 1
Level 1
5 sign-ins First reply posted First question asked

Hello,

We are looking for a stand alone USB3.0/3.1 Hub in our embedded application to increase the number of USB 3.1 port. Stand alone USB hub in the sense, we dont want to use the EEPROM  or  I2C master(or minimum setting) to configure the USB HUB and USB hub should work with default  pre-programmed configuration with out much dependency on the controller.

Can you please suggest us the IC to serve our purpose.

Thanks in advance,

0 Likes
1 Solution
Sananya_14
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hello,

Please check HX3 which provides four USB 3.1 downstream ports. You can set the hub boot mode to internal ROM which has default programmed firmware and configuration for the hub. Please refer to page 24 in the datasheet for more details.

Best Regards,

Sananya

View solution in original post

0 Likes
1 Reply
Sananya_14
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hello,

Please check HX3 which provides four USB 3.1 downstream ports. You can set the hub boot mode to internal ROM which has default programmed firmware and configuration for the hub. Please refer to page 24 in the datasheet for more details.

Best Regards,

Sananya

0 Likes