Apr 01, 2020
12:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2020
12:01 AM
- Is it needed to "Disable flow control" while btattach-ing (bluez) a UART BT device to a Linux Host?
- If yes, why?
This is specified in this tutorial, how to use the dongle:
Thanks.
Solved! Go to Solution.
Labels
1 Solution
Apr 01, 2020
02:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2020
02:58 AM
4 Replies
Apr 01, 2020
02:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2020
02:43 AM
Hi AnHu_4662101 ,
CYBT-413034-02 needs flow control to be enabled for HCI communication. Not sure regarding the test results of blog mentioned.
Did you try hciattach with flow control enabled and see if it works ?
Regards,
Anjana
Apr 01, 2020
02:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2020
02:54 AM
Hi AnjanaM_61,
I've tested both:
- Flow control enabled (default)
- No flow control
`hciattach` is deprecated so I used `btattach` instead. Both cases work.
To confirm, I understand now, recommended way is to "use" the flow control ?
Thanks.
Apr 01, 2020
02:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2020
02:58 AM
Apr 01, 2020
02:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2020
02:59 AM
Thank you for clarification.