- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I tried out the EEPROM emulation example on PSOC4 with Creator 4.3.
Everything works fine and the counter is being updated and printed to serial line whenever I press the reset button on the pioneer board.
But when I program the board again, the content in the EEPROM section is reset/lost. I guess it is overwritten, because the emulation is located in flash and "program" might erasing the whole memory first.
How can I overcome this?
What I want to have is:
use EEPROM emulation, store some values, then continue developing my application, progam and debug it and keep the content.
Can I configure the "program" action to keep the EEPROM location in flash untouched?
Best wishes,
Stefan
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Stefan,
Kindly check the following thread.Is there example code that preserves a user defined area of PSoC internal flash?
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Stefan,
Kindly check the following thread.Is there example code that preserves a user defined area of PSoC internal flash?
Best Regards,
Vasanth