Pull-Up Resistor on the #BYTE Control of Parallel Flash

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
NaMo_1534561
Level 5
Level 5
Distributor - Macnica (Japan)
100 replies posted 100 sign-ins 50 replies posted

When device is configured as word mode, #BYTE pin should be set to the logic high.

What should be the value of the pull-up resistor?

What are the recommended resistor values?

MPN

S29GL064S and

S29AS016J

Best Regards,

Naoaki Morimoto

0 Likes
1 Solution
ShupingZ_76
Employee
Employee
50 solutions authored 25 solutions authored 10 solutions authored

Hi Morimoto-san,

We don't have any recommended value for BYTE# pin pull-up resistor.

If customer wanted to configure the device to word mode, please make sure that BYTE# is higher than the minimum of Vih.

Best regards,

Shuping

View solution in original post

0 Likes
2 Replies
ShupingZ_76
Employee
Employee
50 solutions authored 25 solutions authored 10 solutions authored

Hi Morimoto-san,

We don't have any recommended value for BYTE# pin pull-up resistor.

If customer wanted to configure the device to word mode, please make sure that BYTE# is higher than the minimum of Vih.

Best regards,

Shuping

0 Likes
NaMo_1534561
Level 5
Level 5
Distributor - Macnica (Japan)
100 replies posted 100 sign-ins 50 replies posted

Hello Shuping-san,

I understand your answer. Thank you.

Best Regards,

Naoaki Morimoto

0 Likes