- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When device is configured as word mode, #BYTE pin should be set to the logic high.
What should be the value of the pull-up resistor?
What are the recommended resistor values?
MPN
S29GL064S and
S29AS016J
Best Regards,
Naoaki Morimoto
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Morimoto-san,
We don't have any recommended value for BYTE# pin pull-up resistor.
If customer wanted to configure the device to word mode, please make sure that BYTE# is higher than the minimum of Vih.
Best regards,
Shuping
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Morimoto-san,
We don't have any recommended value for BYTE# pin pull-up resistor.
If customer wanted to configure the device to word mode, please make sure that BYTE# is higher than the minimum of Vih.
Best regards,
Shuping
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Shuping-san,
I understand your answer. Thank you.
Best Regards,
Naoaki Morimoto