- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have posted this issue on the Broadcom CSP site a while ago but haven't got it resolved. I want to see if any of you have tried it and how it goes for you.
I tested snip.p2p with Wiced-SDk-2.4.0 with my smart phone(Andriod) and a Nexus Pad, but the application failed in mid of WPS procedure.
my phone - Android version 4.1.2.
Nexus pad- Android version 4.3
And the console output:
Platform SN8200x initialised
Started ThreadX v5.5
Initialising NetX v5.6
Creating Packet pools
Starting Wiced v2.4.0
WWD SDIO interface initialised
WLAN MAC Address : 00:0B:6C:41:6E:C1
STA MAC: 02:0B:6C:41:6E:C1
P2P discovery enabled. Advertised as 'WICED-P2P'
Found P2P device: Android_85e9
P2P negotiation complete...
Starting WPS Enrollee
Joining 'DIRECT-Vu-Android_85e9'
Sending Identity
Sending Identity
Sending nonce
Sending hashes
WPS Procedure failed. Restarting with 113 seconds left
Joining 'DIRECT-Vu-Android_85e9'
Looking for WPS AP
WPS timed out
WPS complete
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't think this feature is final. Below is from the comments section of the app.
* This application snippet demonstrates usage of Wi-Fi Direct.
* Wi-Fi Direct is still under development, the following
* instructions apply to the current implementation and are
* guaranteed to change for the next release!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I also got same issue when WICED runs as an enrollee.
Will it be fixed on SDK 3.0?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@ Dmiya,
I saw in another thread you said you had WICED working as a GO. I always see WICED starts as an enrollee, what did you do to make WICED a GO.
@ Mus,
It fails at WPS which is working on 2.3.1 , which doesn't make sense. Boardcom asked me to provide sniffer captures but hasn't provided any update after I sent the captures. They didn't say the feature not working.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If the intent is higher than smartphone, WICED will be a GO after GON.
There is no API for autonomous GO I think.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please use new WICED SDK and check whether the issue still persist.
I am closing this thread, you can create new thread if you face the issue in new SDK.