- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Miniprog3 and CY4533 are connected to access HPI Register using Bridge control panel.
For the HPI registers, the following documents were referenced.
https://www.cypress.com/file/490281/download
DEVICE_MODE and SILICON_ID values appear to be different from Document contents.
Reg Addr. Reg.Name Specification Actual Value
0x0000 DEVICE_MODE 0x92 0x95
0x0002 SILICONID 0x11B0 0x2004
Can you tell me why the values are different?
・Document typo?
・Depend on CY4533 Version?
BestRegard
Haya
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
It is a document typo.
The actual value that you read through Miniprog3 is correct.
We will fix this document error in the future.
Best regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
It is a document typo.
The actual value that you read through Miniprog3 is correct.
We will fix this document error in the future.
Best regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your reply.
SILICON_ID value is 0x2003 on the customer's board.Can the SILICON_ID be different for each board?
(DEVICE_MODE value is the same,Two boards at hand SILICON_ID value is the same.)
Best regards
Haya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If the customer purchased BCR at the pretty beginning of the device release, SILICON_ID might be 0x2003.
Currently, SILICON_ID should be 0x2004 as per datasheet.
Best regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I under stand well.Thank you.
Best regards
Haya