- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear All,,,
We are reviewing the product to apply to the power sink we are planning.
I have three questions that I am uncertain about in the review.
Question 1 :
This product supports PD Spec. What is it?
PD3.0 with PSS or PD3.0 without PPS or PD2.0 without PPS?
Question 2 :
On the Cypress homepage, this product supports Apple Charging (2.4A), which is described in the product feature.
However, if I look at the DATASHEET of that product,
I can't confirm that it supports Apple Charging (2.4A).
Please check whether this product supports Apple Charging or not???
Question 3 :
In the datasheet of the chipset, the D + / D- pin is left unconnected,
It is recommended to leave D + / D- pin unconnected on the datasheet of this product.
However, the reference schematic provided in the Evaluation Kit of this product is drawn
to connect the D + / D- pin of the chipset to the usb type-c connector.
What should I do with the D + / D- PIN of the chipset?
Thanks,
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Kindly refer my comments as below:
1. PD3.0 without PPS.
2. It's not support Apple Charging (2.4A).
3. You could wire to Type-C interface or let's floating. Since the BCR is not use the D+/D- currently.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Kindly refer my comments as below:
1. PD3.0 without PPS.
2. It's not support Apple Charging (2.4A).
3. You could wire to Type-C interface or let's floating. Since the BCR is not use the D+/D- currently.
Best Regards,
Lisa