- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm planing to start the project with CCG3pa. firstly, I need to know how to handle PSoC Creator to generate binary file for my project.
So I've downloaded CCGx Power SDK and install PSoC Creator 4.2. and open CYPD3171-24LQXQ_pb project file to check the code sizes.
After building the project, I can see the binary file which is "CYPD3171-24LQXQ_pb.cyacd". this size is 128Kb. even hex file size is 144Kb.
I'm confused with this size, because CCG3PA has only 64Kb flash and 8Kb sram.
So I'd like to know how to check the real code size after compiling project.
because I will write more code inside this project, I should make sure it will be good enough with this 64Kb flash.
Thanks,
Luke.
Solved! Go to Solution.
- Tags:
- ccg3pa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Luke,
Each time you build the project, you can check the actual FW size in the output window:
The PSoC Creator will automatically check the code size. If your code exceeed the limit, your build process will fail.
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Luke,
Each time you build the project, you can check the actual FW size in the output window:
The PSoC Creator will automatically check the code size. If your code exceeed the limit, your build process will fail.
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much for your reply. I just check it as you said.
Luke.