- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
[Products]
- CY8C4147AZI-S445
- CY8C4147AZI-S475
PSoC Creater's Bootloader for PSoC4 As far as I read the specification, it seems that the version upgrade of Main via Booter only supports UART, SPI and I2C.
Q.
Is there a way to use Bootloader with CAN?
Best Regards,
Harukawa
-------------------------------------------------
CypressPSoC CY8C4147 について
CY8C4147AZI-S445
CY8C4147AZI-S475
PSoC Createrの PSoC4用 Bootloaderですが 仕様を読む限り
Booter経由のMainのバージョンアップを UART,SPI,I2Cにしか対応していないようですが
BootloaderをCAN対応にさせられる方法なり 事例なり ありませんでしょうか
以上、よろしくお願い致します。
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Harukawa-san,
PSoC 4 bootloader support custom interface. Please refer the KBA:
-------------------------------------------------
PSoC 4 bootloaderはcustom interfaceをサポートします。 このKBAをご参照ください。
PSoC 4 Custom Bootloader - KBA229075
Best Regards,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Harukawa-san,
PSoC 4 bootloader support custom interface. Please refer the KBA:
-------------------------------------------------
PSoC 4 bootloaderはcustom interfaceをサポートします。 このKBAをご参照ください。
PSoC 4 Custom Bootloader - KBA229075
Best Regards,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi noha_3407421,
In addition to what RuzheZ_36mentioned, you can refer to the following thread that has a project to showcase CAN bootloader in PSoC 5.
CAN Bootloader , Bootloadable Project
Regards,
Bragadeesh
Bragadeesh