- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
What is the most efficient way to control the direction of RS485 data with PSOC4100 ?
Thank you
PG
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Do you mean the absence of tx_en pin in SCB UART?
This was discussed here: SCB mode uart to RS485
I use my simplified hardware version.
It works at speeds up to 115200 baud and a short cable length (up to 1.5m)
circuit below:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi PeGu_352656,
Could you please elaborate your question? Are you referring to the flow control for handshaking in serial communication?
Regards,
Bragadeesh
Bragadeesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Do you mean the absence of tx_en pin in SCB UART?
This was discussed here: SCB mode uart to RS485
I use my simplified hardware version.
It works at speeds up to 115200 baud and a short cable length (up to 1.5m)
circuit below: