- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Anyone happen to know if there is a speed difference flashing with Miniprog 4 vs Kitprog 3?
Even though it's using Daplink v2, the psoc5 (used on the kitprog) has only FullSpeed USB, not sure if the hardware inside the Miniprog supports High Speed?
thx /david
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello David,
Both Kitprog3 and the Miniprog4 have the same firmware, hence there won't be any speed difference. Miniprog4 is essentially Kitprog3 hardware itself but with additional protection circuits needed for programming (i.e to avoid failures due to over voltage etc.).
Hence, Miniprog4 too doesn't support USB high speed, it uses the PSoC5LP which has only USB full speed support.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello David,
Both Kitprog3 and the Miniprog4 have the same firmware, hence there won't be any speed difference. Miniprog4 is essentially Kitprog3 hardware itself but with additional protection circuits needed for programming (i.e to avoid failures due to over voltage etc.).
Hence, Miniprog4 too doesn't support USB high speed, it uses the PSoC5LP which has only USB full speed support.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for info! Is there a schematic available for Miniprog4?