- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Now I try to get authentication in JAPAN. I need to test carrier sense function. I have a question about the test.console project. Can I test carrier sense by test.console project? I’m concerned about that transmission of iperf in test.console project is done based by carrier sense. Because our devices seem to transmit unless in spite of inputting noise to our device.
In addition, is there the command or method to change the threshold of carrier sense?
BRs,
Hiroyuki
Solved! Go to Solution.
- Labels:
-
WICED Studio
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You need to use the mfg test app, and use below list for the CW test , if you want to decrease the TX power, find the NVRAM in the release named with wifi_nvram_image.h , decrease the value with 0x04 every step for the test like from 0x46 to 0x42.
"maxp2ga0=0x4a" | "\x00" | |
"maxp5ga0=0x46,0x46,0x42,0x42" | "\x00" |
wl --serial 106 down
wl --serial 106 country ALL
wl --serial 106 band b
wl --serial 106 mpc 0
wl --serial 106 up
wl --serial 106 out
wl --serial 106 fqacurcy 6
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello:
Do you mean Carrier wave test for wifi?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I would like to test power detection for carrier sensing in 5GHz.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So which chip is used for the test ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You need to use the mfg test app, and use below list for the CW test , if you want to decrease the TX power, find the NVRAM in the release named with wifi_nvram_image.h , decrease the value with 0x04 every step for the test like from 0x46 to 0x42.
"maxp2ga0=0x4a" | "\x00" | |
"maxp5ga0=0x46,0x46,0x42,0x42" | "\x00" |
wl --serial 106 down
wl --serial 106 country ALL
wl --serial 106 band b
wl --serial 106 mpc 0
wl --serial 106 up
wl --serial 106 out
wl --serial 106 fqacurcy 6