- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone
Questions about Output using MBT.
1, Is it possible to measure the RSSI of the destination module using MBTTool?
Sender and receiver use the same module
Do not use dedicated measuring instruments
2, Is it impossible to perform an output test as described in ManufacturingBluetoothTestTool
just by operating from the hostCPU without connecting to a PC?
Thanks
Yang
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
On the hello_client app, I added the following line (after line 1101) in the scan result callback function and I was able to read back the RSSI when the client connects to the sensor.
WICED_BT_TRACE(" RSSI : %d \n", p_scan_result->rssi );
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Yang,
1. No, you cannot measure the RSSI of the destination module.
2. I do not understand your query, please elaborate.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
On the hello_client app, I added the following line (after line 1101) in the scan result callback function and I was able to read back the RSSI when the client connects to the sensor.
WICED_BT_TRACE(" RSSI : %d \n", p_scan_result->rssi );