- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please help me to put CYW920719Q40EVB-01 board in controller mode or (hci mode) where i can send HCI commnds form linux host machine
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please pull the HCI UART CTS pin to high during the power on or external xres reset. Then the device will enter into the HCI mode.
If there is a valid application in the flash, the HCI UART configure will follow the setting in the application.
If there is not a valid application in the flash, the HCI UART is the default 115200 baudrate.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please pull the HCI UART CTS pin to high during the power on or external xres reset. Then the device will enter into the HCI mode.
If there is a valid application in the flash, the HCI UART configure will follow the setting in the application.
If there is not a valid application in the flash, the HCI UART is the default 115200 baudrate.