- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have tried a lot of parameters, but not work? can any one help to tell me what's wrong with it! thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I looked up 7.3 Read_Local_supported_commands and realized that the commands you have highlighted above are not supported. For these commands, a fw or configuration file will have to be downloaded onto the chip before it can be used. Please reach out to your local FAE to support you on this specific needs.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
reset command successful, normal adv and scan successful too, and can set up connection.
but both extend adv and scan failed. I tried many parameters.
can you help to test in your side? Thank you for your help!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The same problem, hope to get a solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi
can you help to check whether this command can be support? thank you!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Below is a link to the user guide to this tool. It has the steps to the most common test setups.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi
my question is not how to use the cybluetool, my question is it seems like all of the Extend adv and extend scan command can not be supported.
can you help to check whether CYBT-423028-Eval can support the v5.0 new added feature.
Thank you for your help!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried a lot of command, most of the v4.2, for example normal adv and scan command, and can set up connection successfully.
so I think the way of use the tool has no problem.
but when I tried to use the extend adv and scan command, failed just as the figure i pased before,
so I have a question whether this borad support v5.0.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I looked up 7.3 Read_Local_supported_commands and realized that the commands you have highlighted above are not supported. For these commands, a fw or configuration file will have to be downloaded onto the chip before it can be used. Please reach out to your local FAE to support you on this specific needs.